Jiangsu Ouring 3D Technology Co.,Ltd
18
3.1 Feeding materials
Feeding materials steps 1 - 8
1.
Separate the nozzle that needs to be fed from the corresponding tube; the specific
method is as follows:
Continue to press down on the blue gasket on the feed nozzle and pull out the
corresponding white tube (as shown below)
2.
After disconnecting the feed nozzle from the material tube, open the package of the
material wire to find the end of the material wire. If the hair is deformed or damaged at
the end of the material, please cut off the wire; By reducing the feed resistance during
the feed, the front end of the filament can be straightened.
Note: After the material yarn is used for material return, the end of the material wire will
usually be melted and deformed. Before re-feeding, please cut off the deformation part
to prevent the blockage phenomenon.
3.
5cm - 8cm
。
After the material wire is prepared, the hand-held material wire is
continuously pushed from the corresponding wire feeder opening until it is exposed 5 cm
- 8 cm from the nozzle tube.
