SIM card slot
6
Products:
•
EH-60
•
EH-686, if an application
has been loaded to the
device
A
B
C
D
EH-200/
EH-105/
yellow
brown
green
jumper wire
Data cable
C
A
EH-60/
EH-686
green
yellow
brown
Data cable
Power supply
230V/12VDC
Power (8–30VDC) is supplied to the modem using either the mains adapter or the battery cable
Products:
•
EH-203, version 2.18
•
EH-105, version 1.75
If EH-60 or EH-686 has a battery
backup, connect the operating vol-
tage directly to the battery char-
ger-power source, AP1. (A power
supply is not needed).
Power supply cable to
8...30V operating voltage
Installation
Set the SIM card to SIM-slot that is in the side of the modem,
so that circuit of the SIM-card is facing towards the sticker
that is on the top of the modem. Press the SIM-card until the
slot snaps and card is properly attached to slot. The SIM-
card can be removed by using a flat object such as a screwd-
river with flat-head.
To be able to use the SMS-connection, the PIN code has to
be installed in the controller. Note. The controller is given the
same PIN as that of the SIM card.
The SIM card’s PIN query
must be on.
Installing SIM card
The
EH-60/
EH-686
should
be powered off after the
modem is connected so that
the device will recognize the
modem.
Connecting the GSM modem to Ouman regulation and control devices
Use a DIN rail to fasten the modem into place. Attach
the DIN rail to the wall.The modem has a preattached
plate that can be attached to the DIN rail.
Place the upper edge of the plate above the upper
edge of the DIN rail.
Press the lower edge of the modem against the rail so
that the hooks on the lower edge of the plate become
attached to the rail.
12 VDC
Bla
Red
A modem which is attached to
the wall, viewed from the back
DIN-rail
Modem
DIN-rail
