29
drain hose
insulating pipe
• Add insulating pipe around the indoor drain hose
in order to prevent condensation.
• The plastic anchors are not provided.
NOTICE
Step 7: Connect wire of indoor unit and repositioning of the ambient sensor
• Open the panel, remove the screw on the
wiring cover and then take the cover off.
• Make the power connection wire go through
the cable-cross hole at the back of indoor unit
and then pull it out from the front side.
• Remove the wire clip; connect the power connection wire to the wiring terminal according to the color;
tighten the screw and then fix the power connection wire with wire clip. After finishing wiring, clamp
the grounding wire (yellow-green wire) into the wire-crossing groove as shown in the following figure,
in order to avoid pressing the wire when closing the electric box cover.
Note: this wiring diagram is for reference only, please always refer to the one on the actual unit.
wiring cover
panel
screw
power connection
wire
cable-cross
hole
3
2
N(1)
outdoor unit
Black
White
(Blue)
Red
(Brown)
Green
(Yellow
-Green)
• Take the ambient temperature sensor in the
electronic board box and insert it in the groove
as per above image.
groove
electronic board
box
Summary of Contents for SED09KCH17S
Page 39: ......
Page 40: ...66129935048 ...