Otto Bock Nurmi Neo, Service Manual, Page: 8 / 27

7
Exchanging the Posterior Frame and the Anti-tipper Holder
It is possible to individually exchange the right and left posterior frame on models size 1 and 2. Model size 3
allows only the complete exchange of the posterior frame.
First remove the grip bar (refer to 4.4).
Loosen and remove the marked screw connections (left figure), on the corresponding side,
between the posterior frame and the folding mechanism (refer to 4.3) and the screw connections between
the posterior and anterior frame.
Then remove the rear wheel (refer to 4.6) and the reverse-roll lock (refer to 4.7).
After loosening and removing the rear wheel, you can pull the
anti-tipper holder
off the posterior frame and
exchange it.
For re-assembly, please proceed in reverse order.
Use new, self-locking nuts.
4.2 Posterior Frame
Exchanging the Multifunction Part
Loosen and remove the marked screw connections
on the multifunction part.
Afterwards you can pull the posterior frame tube out
of the multifunction part.
A mandrel that prevents the turning of the posterior
frame is located in the multifunction part.
For re-assembly, please proceed in reverse order.
Exchanging the Quick-release Mechanism
First pay attention to the arrangement of the bu-
shings and washers so that you can reassemble the
quick-release mechanism later.
Loosen and remove the knurled nut and pull the
quick-release mechanism and all the bushings and
washers out of the multifunction part.
Follow the instructions for adjusting the quick-re-
lease mechanism in the instructions for use.
For re-assembly, please proceed in reverse order.