1 Underside groin strap
4 Long attachment straps
2 Attachment straps with eyelets
5 Strap adjustment and plug connection
3 Free strap ends for adjusting the length
6 Thigh strap
Mounting the groin strap
1) Rivet the clips in the bore holes of the back support frame (see fig. 33, item 1).
2) Place the groin strap, underside down (see fig. 32, item 1), on the seat pad; the attachment straps with the
eyelets (see fig. 32, item 2) must face to the rear.
3) Thread the belt ends of the long attachment strap (see fig. 32, item 4) around the back support to the rear and
secure them in the clips (see fig. 34, item 1).
4) Thread the attachment straps with eyelets (see fig. 32, item 2) between the back support and seat bottom to
the rear and secure them under the seat bottom (see fig. 33, item 2; see fig. 34). Use the screws and wing nuts
to adjust the seat depth and seat width.
5) If necessary, cut off protruding belt ends of the long attachment strap and seal the loose ends by applying heat
(e.g. with a lighter).
2
2
1
11
33
34
17
Kimba
Installing options/accessories
