Otto Bock 476C00-SK45, Instructions For Use Manual

Page: 13 / 140

13
►
Do not wash the product at a temperature higher than specified. The product may be dam­
aged or rendered unusable at higher temperatures.
►
Do not use any bleaching agents or fabric softeners for cleaning.
►
Do not dry clean the product.
► Do not iron the product.
6.3.1 Cleaning
Clean the product regularly depending on the degree of soiling and frequency of use, at least
1x per month
:
1) Use lukewarm water and a mild detergent for cleaning. Add some disinfectant if needed.
2) Soak the product in the water bath. Then wipe the product with a damp disposable cloth.
3) Dry the product with a clean, dry disposable cloth or allow it to air dry.
6.3.2 Disinfection
• Thoroughly clean the product before disinfecting.
• Wipe all parts of the product with a disinfectant.
• Only use colourless water-based disinfectants. Observe the instructions for use provided by
the manufacturer.
7 Maintenance
• The function of the product should be checked
before each use
.
• Check the product monthly for wear and tear, cracks and other damage.
• If the user is very heavy, inspect the product at shorter intervals.
• The user is not permitted to make repairs to the product.
• In case of damage or wear and tear, have the product replaced by qualified personnel as
soon as possible.
8 Disposal information
The product must be disposed of properly in accordance with the respective national environ­
mental regulations.
9 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
9.2 Warranty
Further information on the warranty terms and conditions can be obtained from the qualified per­
sonnel that has fitted this product or the manufacturer's service (see inside back cover for
addresses).
9.3 Service life
Expected lifetime:
6 months
The design, manufacturing and requirements for the intended use of the product are based on the
expected lifetime. These also include the requirements for maintenance, ensuring effectiveness
and the safety of the product.