Otto Bock 2R67, Instructions For Use Manual

Page: 21 / 176

Replace any set screws that are protruding or recessed too much with suit­
able ones (see selection table).
Selection table for set screws
Length [mm] Article number
12 mm 506G3=M8x12-V
14 mm 506G3=M8x14
16 mm 506G3=M8x16
8 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
9 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
►
Conduct annual safety inspections.
10 Legal information
10.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of
the product.
10.2 Trademarks
All product names mentioned in this document are subject without restriction
to the respective applicable trademark laws and are the property of the
respective owners.
All brands, trade names or company names may be registered trademarks
and are the property of the respective owners.
Should trademarks used in this document fail to be explicitly identified as
such, this does not justify the conclusion that the denotation in question is
free of third-party rights.
Ottobock | 21