Page 10
19. Slide the tent over the main frame bar
assembly, then fasten the velcro straps
on the inside of the tent to each main
frame bar. Ref. Diagram 17.
Tent
Main Frame
Assembly
Diagram 17
Note:
Collapsing
the center and front
main frame poles
part way down
will make installation
easier.
45° angle
35
45° angle
8”
33”
23”
16”
33”
23”
20. Once the canvas is on the frame and the Velcro attached, extend all of the frame poles upward and make sure all
of the wind poles are installed. Extend the front adjustable wind pole so that the fabric in front is snug and not
sagging. It will be necessary to loosen the back adjustable wind pole to achieve this. Once the front is set and the
top wind poles are in place, the back adjustable wind pole can be extended until it is snug. Install the plastic trim
lock in the positions shown in Diagram 18.
Install the back center trim lock first and work your way around the sled, pulling the fabric snug as you go. The
canvas will be trapped between the sled lip and the trim lock, and will also wrap underneath the sled lip providing a
very good seal. Check the fit of the canvas and adjust as necessary before installing the screws to hold the trim
lock in place.
Attach the six plastic trim locks (Item 35) to the sled in the locations shown with the 45° angled edge to the inside
of the sled. Ref. Diagram 18.
Diagram 18
