―E18―
7. WELDING PREPERATION (continued)
7.4 Feeding Wire Feeding by Performing Inching Operation
WARNING
●
Do not look into the tip hole to check for the rate of wire feeding while inching.
CAUTION
●
Keep away your hands, fingers, hair or clothes from the rotating parts of the feed
roll, etc. to prevent you from being caught into the rotating parts while inching.
After straightening the welding torch, feed the wire by pressing
the INCHING key. (the INCHING lamp located at the upper right
of the INCHING key lights up). When the wire appears from the
end of the torch, press the INCHING key again (the INCHING
lamp goes out). Cut the wire at about 10 mm from the end of the
torch. Wire feed rate can be adjusted by turning the parameter
adjusting knob.
WARNING
Touching the charging parts may cause fatal electric shocks and burns.
●
Never touch the charging parts in the wire and wire feeder.
The parts indicated as in the figure are the charging parts during welding.
インチング
INCHING key
Parameter adjusting knob
Wire feeding parts
Wire
