OPERATING INSTRUCTIONS
1. Once unit is fully assembled (see Assembly Instructions section) place unit on flat
level surface and plug it into an appropriate electrical outlet.
2. Press the appropriate button to select the desired fan speed or to turn it off. “0” for
“OFF”, “1” for Low Speed, “2” for Medium Speed and “3” for High Speed (see Figure
2).
3. To make the fan head oscillate, push the oscillation knob DOWN. To stop the
oscillation, pull the oscillation knob UP (see Figure 3).
4. Adjust the tilt of the fan head to the desired angle by pushing gently up or down on
the fan guard, while holding the fan by the motor assembly/control panel.
CAUTION: The fan should be switched off before making this adjustment.
Please note that the head will not latch into the low or mid position unless the guard
and blade have been fitted to the motor.
5. To adjust the height of the pedestal fan, loosen the height adjustment collar. Carefully
raise or lower the fan and firmly re-tighten the height adjustment collar.
CAUTION: The fan should be switched off before making this adjustment.
MAINTENANCE AND CLEANING
4
Follow these instructions to correctly and safely care for your fan. Please remember:
• Always unplug the fan before cleaning.
• Do not allow water to drip on or enter into fan housing.
• Be sure to use a soft cloth moistened with a mild soap solution.
• Do not use any of the following as a cleaner: gasoline, thinner, or benzene.
FAN CLEANING
Clean the fan grill, housing and base with a soft, damp cloth. DO NOT ATTEMPT TO
REMOVE THE FAN BLADE. Please use caution around the motor housing area. Do not
allow the motor or other electrical components to be exposed to water.
FAN STORAGE
When storing your fan in the off season, it is important to keep it in a safe dry location. It
is important to protect the fan head from dust. WE STRONGLY RECOMMEND USING
THE ORIGINAL BOX FROM PURCHASE.
00SF1600-LA813_13ESM1.indd 5
4/3/13 4:50 PM
