English-7
Your steam generator takes time to heat up and cool down. If you change the
temperature setting on your steam generator, you must give it time to adjust to the new
setting.
This is especially important when you change from a high setting to a lower one. It takes
your steam generator longer to cool down than it does to heat up and this is the reason
we recommend that you begin ironing at lower temperatures.
For example, you have been ironing using the lino/linen setting and wish to change to the
lana/wool setting:
1. Turn the temperature control dial (5) to set the pointer to the lana/wool setting.
Initially, the temperature indicator light (2) may pulse while the unit adjust to the new
temperature.
2. Wait until the temperature indicator light comes on solidly again. Your steam generator
has now cooled to the correct temperature.
WARNING: Do not use harsh abrasives, chemical cleaners or solvents to clean the
exterior of your iron.
Allow your iron to completely cool down and wipe the soleplate with a soft damp cloth. If
polyester has burnt to the soleplate, iron a damp cotton cloth while your iron is still hot.
Wipe over the rest of your iron with a soft damp cloth then wipe dry. Do not immerse the
appliance or power cord or plug in water or any other liquid.
Only activate the self-clean when you want to activate the self-cleaning system. Never
activate the self-clean function when ironing.
The self-clean function removes scale and impurities. The steam generator has an
intelligent reminder cleaning mode which activates after continuous steam ironing over
a total of 25 hours. If you are in a hard water area you can perform the cleaning cycle
sooner than the allocated 25 hours by following the steps below.
The cleaning indicator light (1) will illuminate to remind users to clean the machine.
1. To activate the self-clean function, adjust the temperature control knob (5) to the Max
setting. Press and hold the self-clean button (1) for 3 seconds. The clean indicator light
will flash. Place the iron handset (3) on the cleaning tray (13) and pull the steam trigger
(4) once then remove hands from the handset, this will initiate the cleaning function.
2. Hot water and steam will be ejected from the holes in the soleplate along with any
impurities. During the cleaning process there is no need to hold the product.
3. The cleaning cycle lasts approximately 1 minute When the clean indicator light stops
flashing, the cleaning cycle is complete, and you can switch off your unit and store
when cooled.
IMPORTANT
CARE AND CLEANING
SELF-CLEANING
