Össur ICELOCK 214, Instructions For Use Manual

Page: 6 / 115

6
6. Grind distal end accurately to expose spacer screw heads (B).
Warning: Do not grind any deeper.
7. Remove spacer screws (B) and attach Lock Body with four long
Countersunk Screws. Use medium strength threadlocker and torque
to 10 Nm.
Note: Push Button may be shortened by unscrewing from Lock Body and
cutting it with hacksaw.
Thermoplastic Instructions
1. Flatten distal end of Plaster Cast enough to centrally attach Delrin
Tooling Body. Attach with nails provided or double-sided tape
maintaining original pin alignment.
2. A small hole may be drilled from edge of Delrin Tooling Body (D)
through length of Plaster Cast to assure maximum vacuum.
3. Attach Lam/Therm Ring to Delrin Tooling Body with Delrin Screw.
Note: Ensure that arrow (A) on Lam/Therm Ring is aligned in AP or
ML direction.
4. Vacuum form thermoplastic. Ensure proper forming, especially at
distal end. Thermoplastic must be at least 6 mm thick at distal end.
5. Rough-cut and grind plastic in the transverse plane, stopping at spacer
screws (B). Warning: Do not grind any deeper.
6. Remove spacer screws (B) and attach Lock Body with four long
Countersunk Screws. Use medium strength threadlocker and torque
to 10 Nm.
Note: Push Button may be shortened by cutting it with hacksaw.
Warning: If Clutch Mechanism is removed during lifetime of lock, torque
to 15 Nm.