Össur Flex Foot Cheetah, Instructions For Use Manual

Page: 5 / 107

5 PB
All other:
Weight kg 45-52 53-59 60-68 69-77 78-88 89-100 101-116 117-130 131-147
Weight lbs 99-115 116-130 131-150 151-170 171-194 195-220 221-256 257-287 288-325
Category 1 2 3 4 5 6 7 8 9
REQUIRED COMPONENTS
The foot can be attached to the socket with direct lamination or by using
one of the following options:
Lamination Connector Kit - see assembly instructions below.
Alignment Adapters - refer to Instructions for relevant alignment adapter.
ASSEMBLY INSTRUCTIONS
CAUTION:
Epoxy can cause allergic reactions when in direct contact with
body.
CAUTION: There may be a cutting hazard due to sharp edges or splinters
on the device.
Nike Soles
The device can be fitted with a Nike spike pad or Nike sole. Refer to
instructions for relevant sole/pad for assembly instructions.
Lamination connector
The lamination connector must be laminated directly onto the posterior
wall of the socket.
WARNING: Before starting, make sure to orient the lamination
connector the correct way. The shoulders of the inserts (marked with
arrow) should be oriented towards the socket
(Figure 1 & 2) .
1. Put the lamination connector in the middle third of the socket to
make height adjustment easier.
2. Make sure the socket surface is flat. A flat surface below the
lamination connector distributes the load from the foot evenly onto
the socket.
3. Use a friction pad between the lamination connecter and the foot.
4. Apply thread locker and torque bolts as shown in the table below.
Lamination connector kits
Device
Lamination connector
kit (FSX50009) Lamination connector
kit, pediatric (CHX50001)
Flex-Foot Cheetah x
Cheetah Xtend x
Cheetah Xtreme x
Cheetah Xcel x
Cheetah Junior x
Cheetah Xpanse x
Weight limit 147 kg 55 kg
Bolt size 3/8” 5/16”
Torque
values [Nm] 45 Nm 28 Nm