Osram AB444200035, Setup Manual

Page: 11 / 43

11
General remarks
Status LED. Release the button now. The device stays in bootloader
mode to download a new firmware.
To exit the bootloader mode, short press the Identify button again.
• Press the Identify button until Status and Error LEDs blink
alternating, then blink together. Releasing the button now resets the
device to its factory settings. The password and other settings are reset
to their default values.
• Keeping the button pressed further on, the device proceeds to
normal operation. No changes apply.
3 General remarks
3.1 Transport
Only transport the device in its original packaging. This protects the device
from damage.
3.2 Unpacking
Only unpack the e:cue SYMPL input Node at its installation location. To
protect the device against condensation water, unpack it and wait until all
moisture remaining in the device has evaporated. Condensation can occur
when the device is moved from a cold to a warm location. Keep the
packaging for use in case of further transport. Inspect all parts for
completeness regarding chapter „2.1 Delivery content“ on page 08. If
there is apparent damage to the device or parts are missing from the
delivery scope, please contact the OSRAM Support service.