36
1
Ultrosonic Sensor
2
2
20Pin jumper wire
Male to female
20cm
some
3
Philips screwdriver
1
4
Hex Screwdriver
1
5
M3 plastic screw
2
6
M3 plastic pillar
2
7
M3 plastic nut
2
Hardware installation
Step 1
: Install the smart car basic frame work as per
you have already completed installation in Lesson 1, just keep it as is.
Step 2
: Remove the screws on copper pillars and add 2pcs IR Obstacle
Avoidance modules onto the car. Install the IR Obstacle Avoidance modules
with 2pcs M3 plastic screws, M3 plastic pillars and M3 plastic nuts at the back
of low car chassis.
Summary of Contents for V2.1
