INSTRUCTIONS FOR INSTALLATION
We reserve the right of alternations
Page
10
3.3.1 Select position for boiler
The boiler should preferably be installed on the lowest point in relation to the installation. This ensures that
elements are always immersed in water and there is no danger of burning out.
When positioning the boiler, ensure there is
adequate space surrounding to allow for pipe
connection, ventilation, servicing and replacement
of components including the immersion heaters.
Refer to diagrams below for guidance.
Access is required to the control panel connections
at underside of the boiler and the power supply
connection, located at left bottom side of boiler.
Ensure the boiler is in a location where it will not be
affected by water drips or splashing.
Ensure that ventilation to the boiler is not impeded
by towels, linen etc placed very close to the boiler.
Do not place towels or linen on top of the boiler.
The figure below shows minimum recommended
clearances
Recommended minimal distances
3.3.2 Fitting the boiler hanging bracket
Fix the hanging bracket (see page 9 No. 3) to the
wall using suitable plastic plugs and M8 or M10
screws (not supplied). Decide the position of the
bottom of the boiler, giving due consideration to the
recommended minimum clearance and then drill
holes to accept the boiler mounting plate.
Screw points should to be drilled the following
distances above the bottom of the boiler casing
RS – E
624mm
Plus – E
610mm
PTV – E
625mm
Wall mounting
Note:
If the boiler is to be fitted in a timber framed building ensure that the bracket is secured to a substantial
part of the timber frame capable of taking the weight of the boiler.
3.3.3 General recommendations when handling
Clear the route before attempting the lift. Ensure safe lifting techniques are used – keep back straight – bend
using legs. Keep load as close to body as possible. Do not twist – reposition feet instead. If 2 persons performing
lift, ensure coordinated movements during lift. Avoid upper body/top heavy bending - do not lean
forward/sideways. Recommend wear suitable cut resistant gloves with good grip to protect against sharp edges
and ensure good grip. Always use assistance if required.
Positioning of Appliance for Final Installation
Lift up boiler (3) above hanging bracket (2), gently lean it to the wall (1) and slide it down to hanging bracket (2).
All manuals and user guides at all-guides.com
