background image

users guide

Your Ideal users guide

ENGINEERED FOR PEACE OF MIND

When replacing any part on this appliance, use only spare parts that you can be 
assured conform to the safety and performance specification that we require. Do not 
use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers.

Harrier GTS
Viceroy GTS
Viscount GTS

All Models

300014486-001-A

Summary of Contents for Harrier GTS

Page 1: ... on this appliance use only spare parts that you can be assured conform to the safety and performance specification that we require Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers Harrier GTS Viceroy GTS Viscount GTS All Models 300014486 001 A ...

Page 2: ...ppliance In cases of repeated or continuous shutdown a recognised installer CORGI registered for gas fired boilers should be called to investigate and rectify the condition causing this and carry out an operational test after each intervention on the device Only the manufacturer s original parts should be used for replacement Minimum Clearances Harrier GTS Clearances of 1000mm 40 at the rear 200mm...

Page 3: ...nce the ignition sequence supplying heat to the system when required Note If the burner does not ignite refer to the burner instructions 6 Set the boiler flow temperature control 3A to the desired setting If a high low burner is fitted set the 2nd stage temperature control 3B to a setting 5o C lower Settings below 4 approx 40o C are not recommended in order to avoid the risk of combustion products...

Page 4: ...eating is detected by the overheat thermostat connected to the boiler control module If the boiler has overheated allow it to cool then press the safety thermostat reset button under the screw top cap 7 and the burner will relight If the fault recurs turn off the boiler and consult a recognised installer CORGI registered for gas fired boilers Escape of Gas Should a gas leak or fault be suspected c...

Reviews: