13
Forandringer forbeholdes - Subject to change without notice - Ändringar kan förekomma
IMPORTANT: All maintenance or repair work must be executed by an approved installer.
Service and parts replacement
Replacing the heating element
A. Disconnect the power cable (8).
B. Remove the electric box lid (3).
C. Shut mixing valve (1) by turning knob (A) fully counterclockwise until valve is fully closed.
D. Open Safety Relief valve (10) for a few seconds to relieve some of the pressure. This is done
by turning knob counter-clockwise. Close the valve by turning the knob fully counter-
clockwise until it snaps shut.
E. Disconnect all wires from the element.
F. Remove the element (5) by using an element socket tool (see spare parts page 10). Some
water will flow from the element connection when removing it.
G. Quickly clean the O-ring slot. Enter the new heating element (5) , with a new O-ring fitted,
into its connection.
Important:
Make sure the element enters the thread correctly and that
the O-ring is placed in its correct position. Tighten element.
H. Open mixing valve (1) using knob (A) and check the element connection for leaks.
I. Refit the wires to the element in their correct positions, tighten properly.
J. Refit the electric box lid and reconnect the power cable (8).
K. Adjust the mixing valve to the preferred temperature setting (see page 10) using knob (A).
A
Replacing the thermostat
a. Disconnect the power cable (8).
b. Remove the lid (3) covering the electric box.
c. Loosen screws labelled 1, 3, 4 and B (see fig. Y) and disconnect the electric wires.
d. Remove thermostat by pulling back slightly on steel clip S using two fingers, then
lifting the thermostat slightly horizontally out of the clip before removing it from the
electrical box.
e. Replace thermostat by again pulling back on steel clip S before slotting the new
thermostat into place.
f. Reconnect the wires to connections 1, 3, 4 and B (see fig. Y), tighten properly.
Important:
Refit the electric box lid before reconnecting the power cable (8).
Note:
All reference numbers relates to fig. X above, except references in pt. c and f which relates to fig. Y.
1
3
2
4
RESET
A
B
BA
CK
ER
19
96
R
5/4
"
S
S
Fig. Y
Fig. X
