11
RECOMMENDATION
- The mains power supply cable (S) should be hidden under one of the channels in the bottom of the
product, as shown in illustration on previous page.
-
> 10A fuse / > 1.5# wire shall be used.
> 15A fuse / > 2.5# wire shall be used.
WARNING
The product shall be filled with water before the power is switched on.
The electrical supply to the heater shall be done in accordance with current local regula-
tions and best practice by a qualified electrician. The product is intended for permanent
supply.
The mains power supply cable shall withstand 90°C. A strain reliever shall be fitted.
CAUTION
The product shall have a clearance for servicing of 40 cm in front of the electric cover / 10
cm over the highest point.
If the mains power supply cable is damaged, it shall be replaced with cable of a quality that
meets the requirements of the installation. The cable must be replaced by a qualified electrician.
The product is equipped with a temperature sensor
bracket which allows installation of a 6 or 8 mm.
temperature sensor. To install the temperature sensor
follow the instructions below.
1.
Remove temperature sensor bracket (A) from
tank body by gripping it and pulling straight out.
2.
Insert temperature sensor (B) firmly into the
appropriate grooves in the sensor bracket and
place the temperature sensor cable in the cable
slot (D).
An 8 mm. sensor (shown) fits in the upper
grooves (C) while a 6 mm. sensor fits in the lower
groove (E).
3.
Refit the sensor bracket into the tank body,
ensuring the bracket is inserted fully to establish
proper contact between the sensor and the
stainless steel inner tank surface. Make sure the
sensor cable is positioned properly in the cable
slot (D) to avoid potential damage to the cable.
B
C
E
D
A
