5.2.3 Resetting the system after filter change
1) Disconnect the system from power supply
2) Lift up the rear tank cover
3) Press and hold the water dispensing button with one hand while connecting
the unit to a power supply, keep holding the button until you hear 4 beeps
4) Disconnect the system again from the power supply
5) Close the rear tank cover
6) Open the rear tank cover again
7) Connect the unit to a power supply
8) Close the rear tank cover
If properly done, maintenance light should disappear and the system goes to
normal filtering mode.
5.3 Failure state
5.3.1 Purification exception
•
The system will show the purification exception state if the machine purifies
water for a long time and cannot stop, all the four temperature icons on the
display will flash. Solution: disconnect power plug and connect power plug
again, check if the purification exception disappears. If not, please remove
and reconnect and carbon and membrane filter. Please contact our helpdesk
if the purification exception persists.
5.3.2 Burning alarm
- The system enters the dry state if the heater works without water or the
temperature exceed the safe setting, the icon for hot water
（
80°C-88°C
）
will
blink, the machine can only dispense normal temperature water but cannot
dispense any kind of hot water. Solution: please contact our helpdesk.
Wh447852323666
Telephone: 0800 002 9533
Email: [email protected]
