Oshkosh IMT Tirehand TH10K135, Manual

Page: 19 / 110

Chapter 3 Installation 17
Lift Truck Installation
1 Mount the Tirehand to lift truck using the original carriage pin.
2 Splice the flow control divider into the existing pressure line. Continue the original line to its
original destination (forklift function, etc.), and route the controlled line (with 12 gpm (45.4 lpm)
at 2500-3000 psi (172.4 - 206.8 bar)) to the tirehand valvebank.
3 Route the hoses as shown in figure below.
4 Locate the control handle inside the cab where convenient to operate.
5 Connect the 3-wire power cable to 12-volt power. The green wire connects to 12V positive,
the black wire to the coil on the flow divider, and the white wire to ground.
6 Route the control cable to the Tirehand and connect.
7 Check all hoses and cables for clearances. Make sure that steering or other movements of
the lift truck will not pinch or overstress the hoses or cables.
8 Fill the reservoir. Start the lift truck’s engine and operate all controls to purge air from the
system.
9 With the lift truck running, check for leaks and repair if necessary.
10 Re-check all hoses and cables for clearance.
11 Check the reservoir oil level and fill if necessary.
12 Test operate the Tirehand.
Courtesy of Crane.Market