iMSO-204x Manual
iOS, Android, PC or Mac Oscilloscope
RevOrig_20170727
10
Up to six measurements can be selected for either CH A or CH B or a combination of both. Once
selected, measurements appear on the top right of the interface.
2.60 Trigger
2.61 Analog Triggering
The trigger level is controlled with the
bubble located on the far right of the screen. If the
bubble is green the triggered signal is CH A. If the bubble is blue, it is triggering on
CH B. To change the trigger from CH A to CH B, touch
. Then touch
. Then simply
select the SOURCE to be triggered.
To change the voltage level, simply touch and drag the bubble either up or down. Moving the
level up will increase the voltage level and moving it down will decrease the voltage level. The
exact voltage level will appear just to the left of the bubble along with either an up arrow or a
down arrow. An up arrow indicates that the trigger is on a rising edge; a down arrow indicates
that the trigger is on a falling edge. It is also possible to change the trigger level in the
advanced triggering menu. Tap
. Then tap
and, when active, it will change to
.
To navigate to an exact trigger level touch on
next to the word LEVEL. The analog
trigger level pick wheel should then appear.
To select the desired trigger level touch and drag in each of the four columns until the specific
value is reached. To activate the settings touch away from the menu. When analog triggering
has been enabled, then all the advanced options for digital triggering will be grayed out.
