12
If there is no wall socket near where the cabinet is to be installed, provide for connection in conformity with the regulations
in force.
Do not use adapter plugs.
The manufacturer has no liability for any damage to personnel or property caused by improper installation.
7 - Technical features
The cabinet is supplied with a plastic bag containing this manual of instructions that must be kept. It contains technical
data, wiring diagrams and tables concerning the cabinet.
The technical data are also shown on the rating plate (FIG. 10 page 3). It indicates:
1. The trade name of the refrigerated cabinet
2. Code corresponding to the refrigerated cabinet
3. Serial number of the refrigerated cabinet
4. Supply
voltage
5. Supply
frequency
6. Maximum power absorbed
7. Maximum power absorbed during defrosting (where provided)
8. Power of standard illumination
9. Usable display area
10. Usable load volume
11. Type of refrigerating gas used in the system
12. Weight of refrigerating gas used to fill each separate system
13. Climatic, environmental and temperature class of reference (dry bulb temperature)
14. Class of refrigerated cabinet depending on the temperature for conservation of the products.
15. Class of safety of electrical system
16. Number of order against which the refrigerated cabinet was produced
17. Order number relative to production of refrigerated cabinet
18. Year of production of refrigerated cabinet
Important:
The rating plate and warning labels should never be removed. The manufacturer is not liable for any damages
caused by failure to respect this regulation.
This is to certify that the product complies with Legislative Decree no. 108 of 25/01/1992 applying EEC Directive 89/109
concerning materials and objects expected to come into contact with food products.
8 - Filling with products and use of the cabinet (startup)
With the cabinet off, remove the plastic film protection on the inside and outside and clean the cabinet according to the
instructions in paragraph 11.
After correctly assembling the cabinet (Par. 5), plug it into the mains (as described in Par. 6) and switch the cabinet on,
switch the light on using the switches on the control panel on the rear (FIG.11 page 3). The gentle hum of the motor and
illumination of the display will indicate that the cabinet is working. The display (FIG.11 page 3) on the rear casing shows
the working temperature of the display case. The instruction manual for the electronic control to which the display refers is
enclosed with the instruction booklet (tampering with this device is impossible because a password is required and only a
specialized expert can modify it). The thermostat and gas charge are set in the factory. Tampering with the factory
settings relieves the manufacturer of any liability.
About three hours after switching the cabinet on, you can start filling it with products. Always check that the temperature
reading on the display of the electronic control is suitable for the conservation of the products placed in the display
cabinet.
The cabinet is designed for the display of food products, which are stored at the temperature of the product, and does not
lower it. The product should therefore be placed in the cabinet only after it has been chilled to its proper storage
temperature.
For better conservation of the product we recommend:
-
Do not obstruct the cold recycle vents that ensure a correct air flow.
-
Leave some room between products to ensure good air circulation.
-
When placing more products inside a partially filled cabinet, in addition to following the above instructions, it is a good
rule to place the new products underneath the existing ones.
-
Never exceed the maximum load line shown on the inside of the island (page 4, FIG.12).
9 - Prohibitions and regulations
Caution
: disconnect the cabinet from the power supply in case it is not used for long time. The power supply has to be
disconnected by the remote-control switch fitted upstream from the power socket.
Caution:
do not expose the cabinet to atmospheric agents, never use jets of water to clean it, do not touch and use the
cabinet with wet or damp feet or hands.
Caution:
do not remove guards or covers that require tools to remove them, never remove the cover on the power panel.
Caution:
do not place heavy loads on the shelves and in the cabinet, and never climb on the counter top.
