Osburn Matrix Installation and Operation Manual
______________________________________________________________________________ 43
•
Remove the latch (M) and reinstall the
screws (L) that were securing the assembly
into the holes.
Note: To avoid dropping the door due to its
weight, get help from another person to perform
the following steps.
•
Remove screws (L) securing the hinges to
the firebox.
•
Rotate the door over 180 degree and
secure the hinges on the other side. It is
important to reinstall the screws in the holes
left by removal of the door.
•
To reverse the door handle (Q), remove the
spring pin (R), the 2 washer (S), and the
assembled balled latch (T) and the
cylindrical pin (U).
•
Unscrew the 2 bolts (N) that holds the
handle guide (O) in place. Remove the
spacers (P).
•
Unscrew the lock nut (V) first, and then the
shoulder screw (X) that holds the door
handle (Q) and the washer (W) on the
handle guide (O).
•
Remove the door handle (Q), rotate it a half
turn and reinstall it in the same location. Put
back the spacers (P).
•
Assemble the handle guide (O) along with
the washer (W) on the door handle (Q) with
the shoulder screw (X) and the nut (V).
Make
sure
the
parts
are
properly
assembled.
•
Secure the handle guide (O) with the 2 bolts
(N).
•
Reinstall the assembled cylindrical pin (U)
and balled latch (T), along with the 2 washer
(S) and secure with the spring pin (R).
To adjust the tightness of the door, see Section
5.1.2 Door adjustment.
