Osburn Designer DV36, Installation And Operation Instructions Manual

Page: 10 / 46

/4
L
IGHTING
P
ROCEDURE
1.
"S
TOP
!"
Read the safety information in the previous section.
2. Set the thermostat to the lowest setting.
3. Turn off all electrical power to the appliance.
4. Open the access door grille, hinged to open downward, by pulling the top grille bar toward you.
5. Push in the gas control knob slightly and turn counter-clockwise to the "
O
FF
" position (Figure 2.1).
6. Wait a minimum of five minutes to clear out any residual gas. If you then smell gas,
S
TOP
!
Follow "
B
"
in the Lighting Instruction section described on the previous page. If you don't smell gas, go to the
next step.
7. Press in the valve knob and turn clockwise to the "
P
ILOT
" position.
8. Push in the control knob all the way and hold it in. Immediately push the piezo ignition button (the red
button to the left) repeatedly so that it clicks. Continue until the pilot ignites. Maintain pressure on the
control knob for about one minute after ignition. Then release the control knob; if the pilot flame goes
out repeat step 8; if the pilot flame remains on then turn the valve knob clockwise to the "
O
N
" position.
9. If the pilot lights but will not stay on after several tries, turn the gas control knob to the "
O
FF
" position
and call your service technician or gas supplier. If the control knob does not pop out when released,
S
TOP
! Shut off the gas supply to the control valve, and
I
MMEDIATELY
call your service technician or
gas supplier.
10. Turn the burner control switch to "
O
N
".
11. Close the access door grille by lifting it and allow the springs to pull it closed.
12. If equipped with a wall switch, select the "
O
N
" position. If equipped with a thermostat or auxiliary
control, set it to the desired setting.
S
HUTDOWN
P
ROCEDURE
1. To turn off the main burner only, turn off the wall switch, thermostat, or
On/Off
switch located behind
the access grille.
2. For complete shutdown of the appliance, depress the valve control knob and turn it counter-clockwise
to the "
O
FF
" position.
2.3 Heat Output Adjustment
The valve supplied with the appliance has a
H
I
/L
O
knob, which may be used to adjust the heat output and
flame height. The
H
I
/L
O
knob may be accessed by opening the lower grilles and rotating the adjustment knob
between its’ two extremes (see Figure 2.1).
N
OTE
:
Adjustment of the knob may be done with the appliance in either the
on
or
off
configurations.