AutoFire® Kiln Controller
User’s Guide
43
Appendix G – Program Lock/Unlock
Please cut out these instructions if you DO NOT want readers of this manual to understand how to
lock and unlock programs on your AutoFire® Controller.
Instructions for
Locking and Unlocking a Program
Refer to previous instructions in User's Manual to
enter into Level 2 Options. Go to Level
2
options and cursor through parameters until
LoUn
is displayed, then press ENTER.
To change between locked (
Lo
) and unlocked (
Un
) mode, press the Delay Start key three
consecutive times. The display will alternate between
Lo
and
Un
for each sequence of three
key presses to the Delay Start key. Press Enter to select mode. The controller will then default
back to Idle mode in about 20 seconds and allow the controller to be operated according to the
mode just selected. Contact Orton for additional information, or programming of this feature.
Be sure to have your particular program entered into the controller, along with any additional
firing parameters, such as firing speed (Cone Fire only), before locking the controller.
Summary of Contents for AutoFire Plus
Page 38: ...AutoFire Kiln Controller User s Guide 36 Appendix C Temperature Equivalents...
Page 41: ...AutoFire Kiln Controller User s Guide 39 Appendix E Connecting Thermocouples...
Page 42: ...AutoFire Kiln Controller User s Guide 40 Appendix F Typical Wiring Diagrams...
Page 43: ...AutoFire Kiln Controller User s Guide 41...
