4. Mounting instructions
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastr.11 • 73119 Zell unter Aichelberg • Germany
11
Tel.: +49 (0) 7164 79701-0 • Fax.: +49 (0) 7164 79701-51 • e-mail: [email protected] • www.ortlieb.net
4 Mounting instructions
The tool-gripper is usually mounted through the taper of the machine spindle. The clamping
segments are already mounted with the ring spring and the rubber shim to the draw-bolt.
-
Make sure, that the machine spindle is cleaned completely and well lubricated.
-
Drive the draw-bar in release position.
-
Screw the complete tool-gripper onto the draw-bar of the machine spindle. Refer to the
installation measures (table: Technical Data p.9 or on the installation drawing).
-
Handle the o-rings and sealings with care (O-rings optionally).
-
The clamping reserve should be at least 2mm (possible stroke from clamping position).
Function:
-
Clamping occurs on pulling, usually by disc-spring or a clamping-cylinder.
-
The draw-bar pulls the draw-bolt with the clamping segments into the machine spindle.
During pulling, the segments were closed by the inner contour of the spindle, grip the pull
stud of the tool and tow it into the spindle till it fits form-locking.
-
To change the tool, the disc-spring is compressed by a hydraulic, pneumatic or electric
cylinder. The draw-bar pushes the tool-gripper to the front, the clamping segments were
spread by the ring-spring and release the pull stud and the tool.
-
Finally, the tool is pushed-out by force, when the draw-bolt hits the face plane of the pull
stud (about 0.5 mm stroke).
-
The tool can be changed manually or automatically by a tool-changer.
-
Pressure to the release cylinder must persist until a new tool is changed in safely.
Pay attention on optional driving pins and slot nuts
