2. Product description
8
Ortlieb Präzisionssysteme GmbH & Co. KG • Jurastr.11 • 73119 Zell unter Aichelberg • Germany
Tel.: +49 (0) 7164 79701-0 • Fax.: +49 (0) 7164 79701-51 • e-mail: [email protected] • www.ortlieb.net
2 Product description
The Ortlieb tool-grippers for tool shanks with 7/24-taper are an approved serial product for
automatic tool changing. They are clamping tools with ISO taper (7/24) and pull studs acc.
DIN 69871/72. The six-piece clamping segment has an optimal load balancing. Therfore a higher
permitted clamping force is possible. And this at faster cyles.
Pos.
Item
1
clamping segment
2
draw-bolt
3
ring spring
4
rubber shim
5
pull stud
6
tool
7
spindle
Function:
Milling spindles on machine tools are usually fitted with conventional spring loaded tool clamping
systems. The tool-gripper operates on pulling force.
The six-piece clamping segment is pulled by the draw-bolt into the machine spindle. The clamping
segment catches the pull stud of the tool and pulls it into the spindle whereas the clamping
segments are backed radial by the spindle-bore.
To change the tool, the disk springs were compressed, usually by a hydraulic cylinder. The draw-
bolt is pushed by the drawbar to the front, releases the clamping segments and pushes the tool by
force out of the spindle taper. The ring spring provides the opening of the clamping segments
which release the tool for changing.
