Ortech Y-H2, Operation & Installation Instructions, Page: 4 / 61

4
Installation
This appliance must be installed or repaired by a qualified technician only.
It is dangerous to modify any part of this appliance.
The manufacturer declines all responsibility in case of failure to adopt proper safety measures.
Ensure the location in which this appliance is installed has good, permanent ventilation.
In ducted mode, there must be one or more permanent air inlet. The air collected must not be discharged into a
duct used to blow off smoke from other appliances fed with electricity.
The distance between the bench to the lower part of the hood must not be less than 60 cm.
Use an electrical connector with earth that is correct for your location.
Check that the voltage in your area corresponds to the appliance as indicated on the rating label.
Do not connect the hood to a duct that carries combustion fumes (e.g. fireplace).
During use
This product is designed for household use only and should never be used for commercial applications.
After use, always ensure that all controls are in the "OFF" position.
When frying over a gas flame, take particular care not to allow the oil or grease in the pan to catch fire.
Cleaning, Maintenance & Service
Clean the grease filters often (at least once monthly). Heavy oil deposits is a fire hazard. Hood surface should be
cleaned with soft cloth and non-corrosive detergent.
Important: Never attempt to repair this appliance by yourself. Always refer to qualified Service Technicians.
For your safety, insist on original parts.
Always switch off the electricity and unplug the connection before conducting maintenance or cleaning.