WARNING
LED Security Light
Sensors
MODEL
OL-
S
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.
1.
LED
Security Light
Sensors
are suitable for using in
dry and damp
locations
2.
Please keep the LED
Security Light
s
a
way
from any corrosive substance, and
please
use
dry
cloth
when you clean it
3.
LED
Security Light
Sensors
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Application Notice
1.
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts / abrasions and other hazards,
please read all warnings and instructions included with and on this product prior to installation
2.
For commercial installation, service and maintenance of this product should be performed by a qualified, licensed electrician
3.
For residential installation, if you are unsure about the installation or maintenance of this product, consult a qualified licensed electrician
4.
DO NOT mount the unit against flammable surfaces
5.
It is recommended that this security light is mounted at least 6' 6" off the ground
6.
Th
e
security light should NOT be used in areas with limited ventilation or high ambient temperatures
7.
The security light CANNOT be used with a dimmer switch, motion or occupancy sensor or other electronic switching device
8.
This product is intended to be connected to a properly installed and grounded UL listed junction box
WARNING — RISK OF ELECTRICAL SHOCK
•
Turn OFF electrical power at fuse or circuit breaker box before wiring product to the power supply
•
Verify if the supply voltage is correct before installing (110V-240V)
•
Make all electrical and grounded connections in accordance with the National Electric Code and any applicable local code requirements
•
All wiring connections should be capped with UL listed wire connectors
WARNING — RISK OF PRODUCT DAMAGE
•
NEVER connect
fixture
with power ON
•
DO NOT mount or support product in a manner that can cut the outer
wire
jacket or damage the wire insulation
•
Avoid covering LED products with insulation, foam or other materials that will prevent convection or conduction cooling
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
CAUTION
Tools Required for Installation:
Phillips screwdriver and level
INSTALLATION GUIDE
The installation of the Security Light Motion Sensor requires making connections to house wiring. If you are not confident
making these connections safely, consult a qualified electrician.
REMINDER:
Apply silicone caulking around the edges of cover plate and in any open holes for a water-tight seal.
