Operator Manual
Cha
pt
er
:
Di
sp
la
y
18
Display
Stand-by Menu
After the initial screen, the LASER is in Stand-by and the following screen appears.
The device status bar informs the user of the device status (Stand-by, Ready, etc.), the current date and time, the temperature of the cooling
liquid etc.
•
Options: Entry key to the Options Menu, where some general LASER settings can be modified, the number of shots verified, the
pump controlled and Firmware updated etc...
•
Start:
Welding session start key.
Options Menu
1.
Language: Menu for selection of the language of the menu.
2.
Info: This screen shows information regarding the device in use. In particular, it is possible to know the firmware version currently
installed.
3.
Counter: From this menu it is possible to check the total number of shots made by the machine. A partial counter is also available,
useful to check every how many shots equipment maintenance is performed.
4.
Timeout:
Selecting
Time-out Display: 1 min
or
5 mins
, with the Laser
Stand-by
status, the
Screen Saver
activates automatically after 1 or
5 mins of inactivity. Selecting
Time-out LASER: 10 mins
, the Laser goes into
Stand-by
after 10 minutes of inactivity.
5.
Pin: This menu can be used to modify the start PIN. The user default PIN is 0000. By pressing the New PIN key, it is possible to modify
the access PIN using the Touch-screen keyboard. First of all, introduction of the Old PIN is requested. Introduce the old Pin and press
OK. If the PIN introduced is correct then introduction of the new PIN will be requested (New 1); Introduce the New PIN and press OK.
Confirmation is requested at this point (New 2). Introduce the PIN again and press OK. If the procedure has been performed
correctly, you automatically go back to the PIN management menu.
6.
H2O Menu for coolant liquid system operations. By pressing the ON key, the cooling circuit pump is triggered and the pointer indicates
the flow in litres per minute in circulation. If the system operates correctly, after a few seconds, the pointer indicates a flow higher than
4 litres per minute in the green section. If the pointer remains in the yellow section or even the red section, the level of liquid must be
checked and, if necessary, coolant must be added or it must be replaced completely.
Information bar
Keys Area
1
2
3
4
5
6
7
8
9
10
11
