Orolia Spectracom VelaSync 1232, User Manual

Page: 43 / 268

2.5.3 Establishing a Network Connection
5. You can chose to communicate with your VelaSync upon setup in one of three ways:
ETH0, using the default static IP address (see step 6),
ETH1-ETH5, using a DHCP network (see step 7),
via the serial port (see "Setting Up an IP Address via the Serial Port" on
page 33 ).
6.
The unit is shipped with one static IP address: ETH0 = 192.168.1.1 . To com-
municate with the Web UI using this address, connect a PC with a configured LAN
port via Ethernet cable to the VelaSync server using ETH0.
7.
To connect a device using DHCP, connect to an Ethernet port without a static IP
address (any Ethernet port except ETH0). Find the unit on your network by con-
tacting your network administrator, and log in to the unit's assigned IP address.
8. Log on to the Web UI (see directions in "Accessing the Web UI" below ).
9.
Note: You'll likely want to change the default IP address of the ETH
ports you plan on using. This procedure is described in the next topic .
(You will need an
Ethernet cable , or a serial null modem cable for
this.)
For more detailed information on network setup, see the section on "Configuring Net-
work Settings" on page 43
2.6 Accessing the Web UI
VelaSync's Web UI is the recommended tool to interact with the device, since it provides
access to nearly all configurable settings, and obtain comprehensive status information
without having to use the Command Line Interpreter (CLI).
You can access the Web UI either by using the manually set static IP address ( ETH0 =
192.168.1.1 ), or by using the DHCP IP address automatically assigned during zero config
setup.
1.
Log into the Web UI as an administrator.
Note: The default login credentials are:
User name = spadmin
Password = admin123
2.6 Accessing the Web UI
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4 31