Orolia Spectracom VelaSync 1232, User Manual

Page: 55 / 268

State
Color/FUNCTION
green
/SYNC
yellow
/HOLDOVER
red
/ALARM
Synchronized On Off Off
Holdover On On Off
No Longer Synchronized Off Off On
Free Run Blink Blink Off
Fault
Code Code Code
The
Fault
state is indicated by the blinking code. It blinks the number of times indicated below, with
a 2-second pause between each set.
Table 2-7:
Fault codes
No. of Blinks Meaning
1 FPGA programming error
2 Failure to decompress
3 CRC failure writing to flash
4 Self-test failure
5 Timing system failure
2.9 Configuring Network Settings
Before configuring the network settings, you need to setup access to VelaSync web user
interface ("Web UI"). For more information, see
"Configuring IP Address(es)" on page 32 .
Login to the Web UI. For more information, see "Accessing the Web UI" on page 31 .
To configure network settings, or monitor your network, navigate to VelaSync's Network
Setup screen.
To access the Network Setup screen:
Navigate to MANAGEMENT > Network Setup . The Network Setup screen is
divided into three panels :
2.9 Configuring Network Settings
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4 43