Checking the location for installation.
2.
Fixing Anchor and Bolt
3.
Make sure to use specified accessory.
¿
Check the positions and intervals.
¿
If the hole positions are not accurate, the gap between MLCD sets can be irregular.
Check the type of wall to examine whether it can
withstand the weight of product.
Check the type and thickness of wall and the finish material.
•
Check the wall can withstand the weight of the product before installation.
•
You can use enclosed anchors and bolts, if the thickness of the finish material is 20mm or less.
•
Never install the product to the wall of gypsum board.
•
Check the installation space.
Select the location suitable for the product size and install to maintain the horizontal and the vertical
•
position.
Leave some space between the product and wall or other structures. (Minimum 15cm)
•
If the product is installed in a closed space, it may be a cause of fire or malfunction for its internal
•
heat.
Drill a hole with 8mm of diameter and
80mm~100mm of depth at the anchor spot
marked at the wall.
Fix the WALL BRACKET and assemble the
washer and the nut.
Fasten the nut securely.
Insert the attachment, and hit it to insert by the
hammer.
Attachment
Washer
Nut
Sleeve
Bolt
Drill
Insert the sleeve along the bolt.
Clean the hole.
Insert the bolt into the hole.
Hammer
WALL BRACKET
- 24 -
www.oriondisplay.net
- 25 -
Infinitely Expandable
MLCD
W
ALL UNIT
