40
Adding Groups To A Scan List
1. With scan operation turned OFF, select the desired group to add to the
selected Trunked system group scan list.
2. Press
<
or
>
on the SCAN add/delete control. The current priority
status of the group will be displayed in column 1 of line one for a time-
out period. If the group is not part of the scan list the status will be
blank.
3. While the status is displayed press
<
to add the group to the scan list.
"S"
is displayed on line one.
4. Press
<
a second time to set the group to Priority 2. A
"2"
is
displayed on line one.
5. Press
<
a third time to set the group to Priority 1. A
"1"
is displayed
on line one. The priority level selection sequence only advances the
group to next higher priority level and stops at priority level 1. To select
a lower priority level, the group must be deleted from the scan list and
then added back to the scan list. Each new group added to the scan list
starts at the lowest priority. If the the Priority 1 and Priority 2 groups
are already set and a new group is assigned as Priority 1 or Priority 2,
the previously assigned group will change to non-priority scanning.
Deleting Groups From A Scan List
1. With scan operation turned OFF, select the desired group to delete from
the selected trunked system's group scan list.
2. Press
<
or
>
on the SCAN add/delete control. The current status of
the group is displayed for a time-out period.
3. Press
>
to delete the group from the scan list.
"S"
,
"2"
or
"1"
turns
OFF. Any group that is not in a trunked system group scan list will show
a
"blank"
for the time period when it is the selected channel.
