7
Installation and User’s Guide
http://www.orionimages.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: 714-766-6300 / Fax: 714-766-6310
pg7
FOR THE VIDEO CONTROLLED TYPE AUTO IRIS LENS
Set the lens selector switch to VIDEO position.
-Connector cable leads -
①
Red (power)
②
Not used
③
White (video)
④
Black (shielded)
*Make proper isolation on the tip of the green wire to prevent a short-circuit.
Auto iris lens
FOR THE DC CONTROLLED TYPE AUTO IRIS LENS
Set the lens selector switch to DC position.
-Connector cable wires -
①
Damping coil (-)
②
Damping coil (+)
③
Driving coil (+)
④
Driving coil (-)
*Connect the wires as shown above.
Please refer also to the instruction of the lens to be used.
Auto iris lens
⑦-⑪
CAMERA SETUP FUNCTION SWITCHES
Please refer to the operation chapter.
⑫
VIDEO OUTPUT CONNECTOR (VIDEO OUT)
For HD-SDI output from camera. Connect this output to HDTV monitor or HDTV
switcher, etc. This to be terminated with 75 ohms impedance at the last equipment
in a loop when cascade / bridge loop connection is made.
⑬
NTSC / PAL OUTPUT
Use a mini-plug connector.
⑭
RS-232C
This is for data value adjustment.
⑮
POWER INDICATOR (POWER)
The LED indicator stays on in green while the camera power is on. This camera
does not have own power on/off switch. Utmost care should be paid when doing
repair or service work.
You may download the camera control application from our website to control this
camera remotely.
DC12V POWER INPUT TERMINAL
For power, apply the input power of DC10 – 16V.
*This installation should be made by a qualified service person and should conform to all local codes.
16
