Orima ORC 15 WA++, Instruction Manual

Page: 51 / 143

In order to understand whether or not the amount of softener salt in your machine is sufficient, check
the transparent section on the salt compartment cap. There is sufficient salt if the transparent section
is green. Salt has to be added if the transparent section is not green
Adjusting salt consumption
Table of Water Hardness Level Settings
If the hardness of the water you use is above 90 dF (French hardness) or if you are using well
water; you are recommended to use filter and water refinement devices.
NOTE: Hardness level is adjusted to level 3 as a factory setting.
Open the
testing
strip.
Run
water
through
your tap
for 1
min.
Keep the
testing
strip in
water for 1
sec.
Shake the
testing strip
after taking it
out of water.
Wait for
1 min. Make your machine’s water hardness
setting according to the result obtained
through the testing strip.
1 6
ENGLISH
12
Testing strip
The washing effectiveness of your machine depends on the softness of the tap water.
For this reason,
your machine is equipped with a system that reduces the hardness
in mains water supply.The washing effectiveness will increase when the system is correctly
set
.To find out the water hardness level of water in your area, contact your local water
board or determine water hardness level by using the test strip(if available).
Water
hardness
degree
German
hardness
dH
French
hardness
dH
British
hardness
dH
Water hardness indicator
1 0-5 0-9 0-6 Wash light is on.
2 6-11 10-20 7-14 End light is on.
3 12-17 21-30 15-21 Start/Pause key is on.
4 18-22 31-40 22-28 Wash light is on.
End light is on.
5 23-31 41-55 29-39 Wash light is on.
Start/Pause key is on.
6. 32-50 56-90 40-63 End light is on.
Start/Pause key is on.