8
9
844·674·4461
WWW.ORIGINACOUSTICS.COM
DSUB6 INSTALLATION MANUAL
You are now ready to attach the port tube to the enclosure. Refer
to the manual included in the port tube carton for instructions.
Figure 9.1: Separate Subwoofer
Amplifier Wiring
3) Connecting the Wires
Strip ¼ to ½ inch (6 to 12 mm) of the insulation off both ends of
the wire and twist the ends to avoid stray strands.
A. When using a 2-Channel Amplifier
Insert the left & right channel wires from the receiver into the
connectors labeled “input from amplifier”, making sure that
the positive wire is being attached to the red connection and
the negative wire is being attached to the black connection.
You will also probably want to run the wires from the
DSUB6’s terminals labeled “output to speakers” at this time.
A zip tie on the enclosure is provided to offer stress release
for the wires.
Figure 8.1: 2-Channel Wiring
B. When using a Separate Subwoofer Amplifier
Use the supplied terminal jumper to connect two of the
DSUB6 input terminals, then connect the positive wire from
the subwoofer amplifier to the positive input terminal and
the negative wire the remaining input terminal. The satellite
speakers will be wired directly to the 2-channel amplifier.
Amplifier
Subwoofer
Amplifier
Amplifier
