9
Problem
Possible cause(s)
The red power lights do not turn on when you plug in the
power.
1. Check if the units are properly connected to the power supply.
2. Check if the power is turned on. If not, Press [ ] to turn on the power.
The green Link light on the Parent Unit is flashing and
cannot hear the sounds from your baby's room.
1. You may have moved out of range. Move closer to the Baby Unit and wait 5 seconds for
the Link to establish.
2. You may need to re−establish the Link between the two units. Turn both units off by
pressing and holding the [ ] and then turn on again by pressing the [ ].
Can't hear your baby on the Parent Unit but the Link
light is still glowing steadily.
Check if the volume is turned up on the Parent Unit.
The Red Power light is flashing on the Parent Unit
Your re-chargeable battery is running low. Return the Parent Unit to the Charger Pod to
recharge it.
Two LED's flash on the parent unit.
1. The battery in the parent unit is not fully charged. Charge the parent unit for 16 hours
before use.
2. The power to the baby unit may be turned off or disconnected, and or the Baby unit may
be turned off. Reconnect the AC power adaptor to the baby unit and or turn on the baby
unit.
3. You may have to re-establish the link between the two units. You will need to remove the
battery from the parent unit and register the parent unit back to the baby unit by following
the instructions below:
Disconnect the power cable from the baby unit, remove the batteries from the parent unit.
Press and hold the power button on the baby unit and connect power to baby unit whilst
you are still holding the power button until the night light flashes rapidly then release
the button. Within 3 seconds push and hold the Page button until the night light flashes
slowly, the baby unit is now in registration mode.
Within 30 seconds hold the power button on the parent unit while inserting the batteries
keep holding the button until the LINK POWER and NOISE LED’s flash. Release the
power button and wait for both parent and baby units to stop flashing (up to 30 seconds)
the parent unit will be registered to the baby unit.
A high pitched ear piercing noise will be heard from the
units (feedback).
Check if the Parent and Baby Units are too close together. Move them further apart.
TROuBLEShOOTING
OR006417 SC110 user manual_04-27-16.indd 9
2016/4/27 17:30:46
