The Answering Machine
27
Appendix
REMOTE ACCESS COMMANDS
Table 1: Commands at the remote menu
Table 2: Commands during message playback
Key Function
Key
Function
2
To play messages
1
To play previous message
4
To play Memo
2
To repeat current message
5
To stop an operation
3
To play next message
6
To play OGM
5
To stop message playback
7
To record Memo
0
To delete current message
8
To switch the answering machine
on/off
9 To
record
OGM
0
Press twice to delete all old messages
Troubleshooting
Problem(s)
Tip(s)
No dial tone
•
Check your phone connections.
•
The handset may be out of range. Move closer to the base.
•
The battery capacity may be low. Charge battery.
Signal icon flashing
•
The handset may be out of range. Move closer to the base.
•
If the handset displays
UNREGISTERED
, register the handset. See page
20.
Registration fails
continuously
•
Your base memory may be full. Delete any un-used handsets and try again.
See page 21.
No parking tone
•
The handset may not be placed properly on the cradle. Try again.
•
Charging contacts may be dirty. Disconnect the power supply first and then
clean contacts with a damp cloth.
•
Turn on the handset tone. See page 18.
Handset on the charger
does not charge
•
The batteries may be defective. Purchase new batteries from your dealer.
•
Check that the batteries are inserted correctly.
•
Make sure the handset is placed properly on the charger. The battery icon
animates while charging.
No display
•
Check that the batteries are charged.
•
Check the power and phone connections.
Bad audio (crackles,
echo, etc.)
•
If you have Broadband installed you MUST install high quality line filters (not
supplied) on all phone sockets. This is not a problem with your phone.
•
The handset may be nearly out of range. Move closer to the base unit.
•
The phone may be interfered by nearby electrical appliances. Move the base
unit.
•
The phone may be at a location with thick walls. Move the base unit.
Handset does not ring
•
Check that the handset ringer is turned on. See page 18.
Caller ID does not
display number
•
Caller ID service may not be activated. Check with your service provider.
•
The caller’s information may be withheld or is unavailable.
Cannot make/answer a
2nd call
•
2nd call service may not be activated. Check with your service provider.
•
Check that the recall selection is correct. See page 19.
•
Check that the correct country has been selected. See page 9.
