2
GETTING STARTED
Getting Started
Installation and Charger
Installation and Charger
1
. Connect the mains adaptor (supplied) to the socket on the back of the base unit
and to the wall mains supply.
2
. Connect the telephone cord to the phone socket on the back of the base unit and
into the wall phone socket.
Important: DO YOU HAVE BOADBAND/ADSL?
If you do, you must connect an in line fi lter (not supplied) between the telephone socket and
your eco5200 base to ensure that your broadband and eco5200 will work properly. If you
do not install the fi lter you will experience interference on the eco5200 and your Broadband
may suffer dropouts. Please refer to the user guide of the in line fi lter for installation.
Note:
In Australia some phone wall sockets are the old non modular style. If you have
this type of wall socket you will need to purchase a “modular converter plug” (not
supplied). These can be obtained from electronic stores.
3
. Insert 2 rechargeable Ni-MH AAA batteries (included), ob-
serving the correct polarity, into the battery compartment on
the handset. Slide the battery door fi rmly into place.
4
. Place the handset on the charging cradle and charge the bat-
teries for a full
15 hours
before using it for the fi rst time.
Note:
It may take some time for the cordless handset to
power up, and it may get warm during initial charge. This is normal.
Tip!
It is good practice to put the cordless handset on the charging cradle when it is not in
use to ensure that the handset is always fully charged.
