Oreck U3795HHS User Manual Download Page 8

Page: 8 / 12

Reassemble the baseplate.

Note:

If the above actions do not correct the problem, contact an Oreck Approved Service

Centre or call Customer Care on

0845 603 0153.

Stuffing or Blockage

IMPORTANT:

ube and the lower tube

few cleanings until all the loose material is removed. Due to t

m. If your vacuum cleaner does not pick up

Check for blockage at the mouth of the intake opening. If there is blockage, remove it with long-

nose pliers, a screwdriver or coat hanger. If you cannot reach the blockage, remove baseplate.

Remove the baseplate by removing 5 screws (see “Adjusting or Replacing Brushroll”).
If the blockage is not at the base, remove lower tube. Unhook bag spring, releasing bottom of bag.
Twist lower collar counterclockwise to slide up. Pull tube out of base.
Check for blockage. If blockage is in the tube, remove with a coat hanger.
If tube is not blocked, look into Fan Housing. Remove debris with long-nose pliers, a

screwdriver or coat hanger.

at base of tube with tab inside Fan Housing. Insert tube and push down until the tube is seated.

Make sure O-ring is in place against Fan Housing opening. Replace and tighten collar until

collar locking tabs are locked in place. Reattach bag spring.
Many times blockage occurs due to a full dust bag causing dirt

When that happens, the blockage will be at the top of the system, starting in the area where the

dust bag connects to the Connector Deflector Assembly.

Replacing Light Bulbs

Maintenance

WARNING:

Unplug cord from electrical socket before servicing.

Remove the baseplate by removing 5 screws.
Remove the belt from the brushroll pulley. Then, remove the brushroll from the housing.
Remove the fascia by removing 2 screws.
Rotate fascia away from the power head and lift it away.
Pull burned out bulb from holder and replace with new bulb.
Reassemble the fascia.
Reassemble the brushroll and belt.

WARNING: Unplug cord from

electrical socket before servicing.