Oreck U3795HHS User Manual Download Page 4

4

1  

2  

3  

2.1  

4  

5  

4  

3  

2.1  

2  

5  

1. When inserting a new disposable dust bag - FIRST PUFF OUT and OPEN THE BAG. 

2. When the disposable dust bag is full, REPLACE IT. 

3. If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service. 
4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these 

motor suction fan and its housing. 

5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the 

vacuum  cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not 

covered under warranty. 

6. For optimal performance, replace the belt every 6 months. 

8. DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord. 
9. Use caution when vacuuming over area rug edges and fringe. 

  

H

 

S

 

I

 

L

 

G

 

N

 

E

Assembling the Appliance  

Up-Position Lock -

Place foot on power head and lean handle back gently to release lock for 

vacuum use. Return handle to the full upright position to engage lock. 

Note:

 Do not operate the 

unit while in the upright and locked position. Do not let the unit run while in any one stationary 

position for any period of time. Keep the unit moving while in operation.  

Easy Power Cord Storage - 

Wrap power cord around cord hook on handle and cord hook on 

Connector Deflector Assembly.   

Operating Instructions  

The following are a few simple suggestions regarding its operation:  

Before assembling appliance, remove two screws from the Connector Assembly. Remove 

plastic insert by pulling upward. 
Slide upper handle section over the matching section of the Connector Assembly. Hold tab of 

TOP 

hole in Connector Assembly. Insert screw through hole in 

Loop the Power Cord through the Strain Relief Kit as illustrated.  
Take hold of the Harness (21 on parts list pg 3) - and push it into the clip located on the left 

Make sure the disposable dust bag is in place. 

DO NOT

operate the cleaner without a dust bag. 

Plug the power cord into an electrical socket and press the 

On ( 

) - OFF ( 

)

switch on  handle  

assembly when ready to operate.  

Operation  

1  

Operating the vacuum  

You’ll love the way your Oreck cleans under things and is SO lightweight and easy to use.  

Summary of Contents for U3795HHS













Reviews: