Righteous 3D II User's Manual
Section 1: Hardware Installation
10
Scanline Interleave (SLI) Feature
Two Righteous 3D II’s of the
same memory configuration
can be connected together to double the texture fill-
rate and enable resolutions up to 1024x768. When
connected by the supplied SLI configuration cable, the
cards automatically enter SLI mode and work simulta-
neously on each frame of animation.
Connecting two Righteous 3D II's
The following instructions assume that you have al-
ready installed one Righteous 3D II card.
1.
Select a PCI slot next to the Righteous 3D II
installed.
2.
Carefully hold the second Righteous 3D II by the
top edges and lower it into the PCI expansion slot.
Ensure that it seats firmly into the slot.
3.
Connect each end of the SLI configuration cable to
the 34-pin SLI configuration connector on each
card.
4.
Connect the VGA pass-through cable and monitor
cable to one of the Righteous 3D II cards.
The
Righteous
3D II drivers
will auto-
detect which
card your
monitor is
plugged into
and drive it
properly.
Figure 1.4:
Righteous 3D II
SLI Configuration
