5
System Programming
All programming is done on Extension 201 ONLY.
NOTE:
If Programming is being done successfully you will hear a single Beep
(beep)
or a voice
confirmation after every
#
, if unsuccessful you will hear a Series of Beeps or a voice confirmation
after the
#
.
In this guide all dialled digits will appear in
RED
text.
System Password
The factory default password is:
* * 0 1 (1234) #
You only need to enter the password if you are starting a new programming sequence
.
Changing the Password
Ext 201 Dial: Current Password
* * 0 1 1234 #
(beep)
Dial: New Password
* * 0 2 xxxx #
(beep) Hang Up
NB: Your new Password will be:
* * 0 1 xxxx #
Resetting the password. If you forget the new password you reset to the factory default:
On ext 201 Dial:
* * 03 03 03 #
Beep
The password will now be * * 01 1234 #
NOTE:
When you enter the programming mode on 201 all the other Extensions will be cut off.
Therefore ensure that other Extensions are not on calls before you start programming.
We strongly recommend that you store your new password into a one-touch memory.
This will simplify all future programming.
