(18.12.17) OC_GFX_BA_790144762_00_EN
orbitalum tools
GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0
27
GFX 3.0, GFX 6.6
| Operating instructions
Set-up and assembly
8.4
Saw blade clamping point 1: Fitting the saw blade/bevel cutter
IMPORTANT
Warning messages are used in these instructions to warn you of possible risk of death, injury or dam-
age to property. Always read and observe these warning messages! To ensure safe setting up and
mounting please read all the warning messages in chap. 2, p. 6 and chap. 8, p. 23 attentively.
WARNING
Hot components!
Danger of injury to hands.
X
Wear suitable safety gloves when replacing the saw blade (in accordance with DIN EN 388 and
EN 407, see chap. 2.4, p. 8).
X
Lay down the tools and fastening parts rapidly.
Only use saw blade clamping point 1
to cut and bevel tubes
. If you want to cutting tube
elbows, use saw blade clamping point 2 (see chap. 8.5, p. 28).
NOTE
Saw blades/bevel cutters can only be fitted or replaced if
no
tube is
clamped in the vice. If necessary, remove the tube before fitting the
saw blade.
2
1
8.4.1
Inserting the saw blade
1. Turn the tube cutter clockwise and upwards by 180°.
2. Tighten the locking screw (2).
3. Loose the nut (5) clockwise (left-hand thread).
4. Clean the saw blade shaft (1) and vicinity with a brush.
5. Place the saw blade (3) and clamping disc (4) onto the
shaft (1).
IMPORTANT Put the saw blade onto the shaft so that the
inscription points to the machine. The tooth-
ing then points in the right direction.
6. Tighten nut (5) counterclockwise (left-hand thread).
7. Loosen the locking screw (2).
8. Turn the tube cutter clockwise and downwards to its
home position.
