WARNING!
Before performing any maintenance to your treadmill, always unplug
the power cord from the surge protector.
CLEANING:
Routine cleaning of your TREADMILL will extend the life of your
treadmill.
WARNING!
To prevent electrical shock, be sure the power to the treadmill is
OFF and the unit is unplugged from the wall electrical outlet before attempting any
cleaning or maintenance.
AFTER EACH WORKOUT:
Wipe off the console and other treadmill surfaces
with a clean, water dampened soft cloth to remove excess perspiration.
USE NO
CHEMICALS.
WEEKLY:
Use of a treadmill mat is recommended for ease of cleaning. Dirt from
your shoes contacts the belt and eventually ends up underneath the treadmill.
Vacuum underneath the treadmill once a week.
DECK LUBRICATION:
The walking belt has been pre-lubricated at the factory.
However, it is recommended that the walking board be checked periodically for
lubrication to ensure optimal treadmill performance. Every 10 days or 10 hours of
operation, lift the sides of the walking belt and feel the top surface of the walking
board as far under as you can reach. If you feel signs of silicone, no further
lubrication is required. If it feels dry to the touch, lubrication is needed. Ask your
retailer or call Service line for the type of silicone.
TO APPLY LUBRICANT TO THE WALKING BOARD
1) Position the walking belt so that the seam is located on top and in the center
of the center of the walking board.
2) Insert the spray nozzle into the spray head of the lubricant can.
3) While lifting the side of the walking belt, position the spray nozzle between the
walking belt and the board approximately 10cm from the front of the treadmill.
Apply the silicone spray to the walking board, moving from the front of the
treadmill to the rear. Repeat this on the other side of the belt. Spray
approximately 4 seconds on each side.
4) Allow the silicone to 'set' for one minute before using the treadmill.
WARNING:
Do not over-lubricate the walking board. Excess lubricant should be
wiped off with a clean towel
23
MAINTENANCE
Summary of Contents for StarStrider SS55C
Page 1: ......
Page 26: ...25 EXPLODED DRAWING ...