Orbit baby Toddler, Manual, Page: 23 / 55

Rear
-Facing Installation
44
44
Rear
-Facing Installation
45
45
1. Remove the Toddler Car Seat from your
car or have the Toddler Car Seat docked
securely either directly Forward- or
Rear-Facing on the Orbit Stroller.
2. Turn the Locking Knob on the Brace to
the UNLOCKED position by fi rst pushing
it in, then turning (Photo R).
3. Pull out evenly on both sides of the
Brace until the Brace Rods disengage
completely from the shell (Photo S).
4. By rotating one Brace around, you
can dock the Braces together in their
storage position (Photo T). Replace the
Braces in their Brace Bag. Store them
in a safe place, or in the Cargo Pod of
your Orbit Stroller for later use.
Removing the Braces
1. Attach the Braces in a Rear-Facing
position: see pages 41-43.
2. To access the LATCH Belt, open the
Rear Access Panel by unclipping the
Back Clip (Photo U).
3. Remove the LATCH connectors from
their pockets (Photo V). The LATCH Belt
is permanently attached to the Toddler
Car Seat by the LATCH Leash.
4. For ease of installation, lengthen
the LATCH belt by pressing the grey
pushbutton adjuster on the buckle and
pulling on the belt.
5. When closing the Rear Access Panel,
look for the notches on the sides near
the bottom of the Panel (photo W).
Position the LATCH Leash in either
notch so that the panel closes. Close
the clip on the back of the Rear Access
Panel to secure.
Installation with Braces
& LATCH System
(without Orbit Base)
R
S
T
U
V
W
Back Clip
Rear Access Panel
LATCH Connectors