Orbit baby G3, Instruction Manual

Page: 27 / 122

Instruction Manual - Car Seat + Isofix Base
Group 0+
- 27
Note: A small amount of rotational movement is normal, but the car seat should
not rotate out of the rear-facing position and the rotation indicators should not be
showing red.
Rotating and removing the car seat
□
Squeeze both release levers
Ⓝ
upward. As you squeeze the release levers, the car
seat can be rotated and lifted off of the SmartHub.
Removing the base
□
Adjust the support leg by twisting the support leg knob anti-clockwise. While holding
the support leg knob, retract the support leg until it CLICKS into a low-numbered
position on both sides.
□
Remove the car seat base from the vehicle seat by pulling back on BOTH ISOFIX
release sleeves
Ⓗ
in the direction of the arrows to release the ISOFIX connectors.
The ISOFIX indicator window will show red when they are released.
□
If it is difficult to release the ISOFIX connectors, twist the rebound knob anti-
clockwise and pull the rebound bar handle until it CLICKS into a low-numbered
position.
□
Remove the support leg by flipping the car seat base upside-down. Locate the
release pins and use a small object (such as a pen) to depress the pin while pulling
the support leg. Repeat on the opposite side to completely remove the support leg.