SAVE THESE INSTRUCTION FOR FUTURE REFERENCE
OPERATION (Figure 1)
1
Carefully remove the Heater from the bag and the carton.
2
Place the Heater on a firm, level surface.
3
Plug the cord set into a
230V
electrical outlet. When the Heater is initially plugged in, there will be a “beep” and
the red light will come on indicating that there is power to the unit. The red light will remain lit until the Heater is
unplugged from the electrical outlet.
4
Pressing the power button (
)
(
Figure 1)
this heater will come into FAN mode, it will blow cool air, also the
current room temperature will be displayed.
5
Once pressing the MODE button (
), the unit will be in the LOW HEAT mode. (750Watts)
6
Pressing the MODE button (
) again, the unit will be in the HIGH HEAT mode. (1500Watts)
7
Re-pressing the MODE button (
) again, at this point will set the Heater into AUTO-SET TEMP mode. Notice
that the display now displays a SET TEMP indicator. (See Thermostat Instructions)
8
If you want to stop the heater working, press the power button (
) again.
9
Swing function:
This function will work in any mode. Pressing the (
) button will allow the Heater to oscillate
left and right. To stop the oscillation, press the Swing button
(
)
once more.
10
Timer function:
This function will work in any mode. The timer function allows you to set the length of operation
from 1 hour to 8 hours. Pressing the (
) button increase the length of operation by 1 hour each time the button is
pressed till to 8h. Once the timer has been set, the timer will count down the hours in 1 hour increments, until the
heater will turn itself off. The operation time will be not displayed 10 seconds later after you finish set the working
time, the remaining operating time only will be showed till you press (
) button again.
FIGURE 1
THERMOSTAT INSTRUCTIONS
1
Press the MODE button (
)
until the display shows AUTO Mode.
2
To adjust SET TEMP, press the (
)
to increase the desired temperature and the (
)
to decrease the desired
temperature.
3
When the air temperature raises 3 degrees above the set temperature, the heater will cut off after 20 seconds.
4
When the air temperature drops below the set temperature, the unit will come back on.
Note: It is normal for the Heater to cycle ON and OFF as it maintains the set temperature.
SAFETY FEATURES
1.
A thermal overload protector is built in to prevent overheating.
2
When an overheat temperature is reached, the Heater will be automatically shut off.
